Dinan's Free Flow axle-back is built for the 2008-2011 BMW M3 sedan with the S65 4.0L V8, and it uses 304 stainless steel throughout. The design relies on a Helmholtz chamber and a single-channel absorption layout that aims to increase flow while reducing unwanted noise. Compared with the factory system, the single-channel dual exhaust is a full 10 lbs lighter than the stock BMW part. The manufacturer's E9x M3 white paper claims a gain of 6 horsepower and 5 lb-ft of torque. Owners on user forums describe the sound as no drone, as advertised, with a tone at wide-open throttle that they especially like. The stainless build carries a 4 year/50,000 mile warranty, which is the manufacturer's stated coverage.
This E90-specific Dinan kit is the sedan version, so it is not the same part as the coupe and convertible system. The exhaust tips are different lengths between the E90 and E92/E93 Dinan M3 exhausts. The manufacturer lists E90 tips at 8.7" and 9.2" long. Installation is aimed at the driveway mechanic: the manufacturer describes a simple installation that uses high quality BMW OEM clamps and hangers. Searching for an E90 M3 Dinan axleback, stainless free flow muffler, or black tip exhaust for a 2008-2011 M3 sedan will match this part.
No. The manufacturer lists this part (D660-0028) for the E90 sedan only. Coupe and convertible models use a separate Dinan Free Flow axle-back, part number D660-0027.
The manufacturer's install sheet says to measure the tips. E90 tips measure 8.7 inches and 9.2 inches long, while E92/E93 tips are longer. Check this before you cut or remove the stock system.
Owners on user forums report that the system is quiet at steady cruise, and that the sound opens up under harder acceleration. Results vary with driving style and the rest of the exhaust.
The manufacturer says some mechanical skill is required, and recommends a qualified BMW repair facility if you are not comfortable with the procedure. The job involves supporting the car on jack stands, unbolting the stock muffler and its rubber hangers, and fitting the Dinan mufflers to the factory inlet pipes using the provided clamps. Owners on user forums say the hardest step is removing the stock hangers, and one owner completed the job alone on ramps in a driveway. Plan on a few hours with a 10mm socket set and copper locknuts for the hanger hardware, and measure the tips before you start.