The aFe MagnumFLOW Pro-GUARD 7 (PG7) 72-90085 is an oiled conical replacement air filter built on a 100% polyurethane top and base. The manufacturer describes the PG7 media as five layers of progressively finer oiled cotton gauze plus two synthetic layers, and its tall, evenly spaced pleats add dust-holding capacity between cleanings. A pliable polyurethane flange with integrated bumps is meant to seal without gaskets. Compared with a stock paper element, the manufacturer states that this filter outflows paper, and because it is washable and reusable, the per-service cost is limited to cleaning oil and cleaner. Owners searching for a reusable oiled cotton-gauze PG7 replacement for an aFe Magnum FORCE intake will find this is the PG7 counterpart of the Pro 5R 24-90085 element.
The manufacturer's fitment table lists 72-90085 with an 11 x 6 inch base, a 9.5 x 4.5 inch top, and a 6 inch height, so measure your intake's flange and housing clearance before ordering. Element swaps are generally a tool-light job, but confirm the seal sits flat before closing the airbox. Long-tail search terms this filter matches include aFe PG7 72-90085 replacement filter, Magnum FORCE PG7 intake filter, oiled cotton gauze conical air filter, reusable washable performance air filter, and polyurethane bump seal air filter.
The manufacturer lists 72-90085 alongside the Pro 5R Magnum FORCE element 24-90085 and gives its base, top, and height dimensions. Flange size is not consistently stated across sources, so confirm the inlet diameter against your intake before ordering.
According to the manufacturer, the Pro-GUARD 7 media uses five oiled cotton gauze layers plus two synthetic layers, while the Pro 5R uses five cotton gauze layers. The PG7 is recharged with the gold oil from the Pro-GUARD 7 restore kit, while the Pro 5R uses the blue oil.
The manufacturer states that Pro-GUARD 7 filters can be recharged with aFe's POWER cleaner and gold air filter oil, using the Pro-GUARD 7 Restore Kit (90-50500). Owners on user forums suggest soaking the media with cleaner, rinsing, letting it dry, then oiling one side of the pleats only.
No. Owners on user forums stress that an aFe oiled filter should never be run without oil, and that over-cleaning should be avoided because the media is designed to keep flowing as long as the mesh is still visible through the oil.
Swapping the element is a low-difficulty job with basic hand tools, but the cleaning and re-oiling process is where most mistakes happen. Clean the element with the manufacturer's Pro-GUARD 7 cleaner, rinse gently, and allow it to air dry fully before oiling. Apply the gold oil to the pleats while stopping about 1/2 to 3/4 inch from the edge, and let it wick through the media. Owners on user forums warn against using only the cleaner without re-oiling, applying too much oil, or running the filter dry.