The K&N 33-2991 is a reusable panel-style replacement that drops into the factory airbox of the Range Rover Evoque. The manufacturer describes layered, oiled cotton media engineered to improve airflow and capture contaminants, and its product page lists Overall Filter Efficiency · Up To 99% Efficiency. Because the element is washable, you clean and re-oil it instead of buying a new paper filter at each service, which is where the long-term cost case against a disposable stock element comes from.
Set expectations on power. Owners on user forums say the main draw is airflow and long service life, and one reported no measurable horsepower change when fitted on its own inside a stock airbox, so treat it as a durable airflow upgrade rather than a standalone power mod. Fitment is the detail to verify. The manufacturer's application list places this filter on the 2.0L petrol and 2.2L diesel, while the 2.0L L4 diesel uses K&N 33-3073 instead. Confirm your engine code before ordering this Evoque air filter for a 2.0 diesel or a 2.2 diesel.
Per the manufacturer's application list, the 33-2991 is listed for the 2.0L petrol and 2.2L diesel. The 2.0L diesel is listed under K&N 33-3073, so check your engine before ordering.
The filter arrives pre-oiled. Owners on user forums recommend wiping off the excess oil before fitting it so that oil does not reach the mass airflow sensor.
The manufacturer states the filter is washable and reusable and is designed to last the life of the vehicle, with cleaning and re-oiling at each service interval.
This is a beginner-friendly swap. The manufacturer lists the DIY level as easy, a screwdriver as the typical tool, and an installation time of 5-10 minutes. Owners on user forums report removing the six screws on the airbox cover and lifting the old element out, though some recommend cleaning the intake while the housing is open. Seat the new panel fully in its groove and close the lid gently. The manufacturer's general guidance is that clips may need more force with a K&N filter than with a foam-sealed OEM element, so do not force the lid if the filter is misaligned.
