The aFe 30-10284 is a Magnum FLOW OE replacement panel filter built on the brand's Pro 5R platform, which the manufacturer describes as five layers of progressive oiled cotton gauze for maximum flow. The manufacturer says up to a 25% increase in flow over stock was measured on this part number. Its full 360-degree polyurethane frame holds its molded shape under engine-bay heat, and the manufacturer backs its factory-replacement performance filters with a limited lifetime warranty. Because the media is washable, owners can recharge it with aFe's cleaner and blue filter oil instead of rebuying every service interval. The manufacturer states its oil is safe for MAF sensors, even when over-oiling, which matters on a supercharged V8. The manufacturer lists this application as Land Rover Range Rover 10-22 V8-5.0L, while the product title reads 10-21, so confirm your model year before ordering.
For DIY work, owners on user forums describe the job as open the hood, unscrew the screws holding the large black boxes on either side and swap the filters, and one owner estimated about 10 minutes. A Phillips driver handles most fasteners, though a flat head screwdriver may be needed to loosen the clamps on the air tubes. Owners also recommend cleaning the MAF sensor during the same service. Searches for this part often include "aFe Pro 5R Range Rover 5.0 supercharged air filter," "Magnum FLOW V8 intake filter," and "washable oiled air filter track use."
The manufacturer sells this part number as a single filter and lists the two-filter pair separately under 30-10284-MA. Owners on user forums report that Range Rover V8 models use two air boxes, one on each side, so confirm the quantity your vehicle requires before ordering.
The manufacturer states that its oiled filters are made with no contaminants and will not damage the MAF sensor, even when over-oiled. Owners still recommend cleaning the MAF sensor during filter service.
Installation is a beginner-friendly job, typically requiring a Phillips screwdriver and sometimes a flat-head for the hose clamps. Owners on user forums note that one bolt can be difficult to reach, so an extension or a stubby driver helps. Before removing the old element, loosen the air tube clamps carefully and keep the MAF sensor clean; owners suggest using a dedicated MAF cleaner while the housing is open.