The Mishimoto BNWS-014-381BK is a pair of 1.5-inch (38.1mm) black wheel spacers made for the 5x127 (5x5) bolt pattern on 2007-2018 Jeep Wrangler JK models. Each spacer is forged from 6061-T6 aluminum and finished with a black anodized coating that the manufacturer positions as corrosion protection. The spacers are hub-centric: a 71.6mm center bore seats over the factory hub so the vehicle's weight is carried by the hub rather than the studs, which the manufacturer says reduces the vibration and wheel movement common with lug-centric spacers. Grade-12.9 steel studs and lug nuts are included, and the manufacturer backs the kit with a lifetime warranty. For a trail or overland build that needs more outward offset, forged hub-centric 5x5 spacers with 1/2-20 studs are a stronger choice than thin cast units, which owners on Wrangler forums tend to avoid because they can crack under side loading. Searchers looking for 1.5 inch JK wheel spacers, hub-centric 5x127 Wrangler spacers, or forged 6061 trail spacers will find this part matches those needs.
Owners on Wrangler forums commonly report that 1-inch and 1.25-inch spacers may leave stock studs protruding above the spacer, which can mean trimming studs or fitting shorter hardware. A 1.5-inch spacer generally covers the factory studs fully, and one JK owner who went this route described a better stance and ride. Because the spacer hides the lug nuts, a loose nut is hard to spot during routine checks, so a torque check after installation and periodic re-torquing matter. Before ordering, confirm the manufacturer's stated fitment for your exact year, trim, and wheel offset, and confirm that your factory studs will clear the spacer.
The manufacturer lists this specific part (BNWS-014-381BK) for the 2007-2018 Jeep Wrangler JK. Confirm with the manufacturer before using it on any other application, since fitment depends on the bolt pattern, hub bore, and stud length.
The manufacturer notes that trimming stock wheel studs may be required to prevent interference with the wheel. Installers must also make sure the stock studs do not contact the back of the wheel once the spacer is installed. Owners on user forums report that 1.5-inch spacers generally cover the studs without modification, while thinner spacers more often require trimming.
The manufacturer says not to use anti-seize or other lubricants on any threaded parts, including the stud, lug nut, or lug bolt. User forums discuss thread locker use, but since the manufacturer's guidance is to avoid lubricants on threads, check with the manufacturer before applying any thread product.
The manufacturer rates this kit as an easy install. Start by removing the wheel and cleaning any corrosion from the hub surface before the spacer goes on, since the manufacturer's guide calls for removing corrosion first. Seat the spacer fully against the hub, then use the supplied lug nuts to fasten it, making sure each lug nut engages the studs for at least seven full turns. Mount the wheel so it sits flush against the spacer, then tighten everything with a torque wrench to the vehicle manufacturer's specification. Do not use pneumatic or electric impact tools on the spacer or its hardware, because the manufacturer warns against them. Re-check the lug nut torque after the first 25 miles, and re-torque at regular tire service intervals. Watch for brake rotor stud clips on the factory studs, which owners report may need to be removed with pliers so the wheel sits flat.