Mishimoto's full-flow thermal bypass valve is a CNC-machined billet aluminum replacement for the factory bypass valve on 2019-2024 RAM 2500 and 3500 trucks with the 6.7L Cummins I6. The valve removes the internal thermostat so fluid is routed to the transmission cooler under all running conditions. That makes it a practical choice for owners who tow heavy loads or operate in hot climates, where a thermostat-controlled bypass can hold back flow the cooler needs. Its internal passages are machined to flow better than the stock valve, and the housing carries a Mishimoto Lifetime Warranty.
Installation is a realistic weekend task. The manufacturer's install guide lists the job as roughly 20 minutes, and it begins by setting a drain pan under the stock valve because fluid will escape when the lines come off. A 20mm wrench loosens the transmission-side fittings, and a 10mm wrench releases the bolt securing the cooler-side lines. The old O-rings on the transmission-side lines get swapped for the new ones included in the kit, and the two supplied Dowty seals go on the cooler-side lines. Search terms buyers typically use include "2019-2024 RAM 2500 6.7L transmission bypass upgrade," "RAM 3500 Cummins transmission cooler flow," and "6.7 Cummins full flow bypass valve install."
The manufacturer lists this valve for 2019-2024 RAM 2500 and RAM 3500 trucks equipped with the 6.7L Cummins I6. Confirm your VIN-level configuration with the manufacturer before ordering if your truck falls outside those years.
The manufacturer's thermostatic kit for the same trucks uses a replaceable thermostat that is more durable than the stock thermostat and opens about 10 F earlier. The full-flow valve instead omits the thermostat entirely, so it is better suited to hot-climate or heavy-towing use than to cold-weather warm-up.
Per the manufacturer's install guide, the job requires a 20mm wrench and a 10mm wrench, plus a drain pan for the fluid that escapes once the lines are disconnected. Work through the four lines one at a time so each goes back to its matching port, and install the new Dowty seals on the cooler-side connections before reassembly. Check the transmission fluid level after the truck has run and inspect every fitting for seepage, since the fluid is the only thing keeping the transmission cooled and lubricated.