A multi-layer aluminum skin over a high-density core gives the BAK 450126 its rigidity, and the MX4 EZ-Lift design is sized for the 5-foot-2-inch bed of 2015–2022 Chevrolet Colorado and GMC Canyon trucks. The matte black finish is cited as the same on all surfaces. Hard panels resist flex and sag far better than soft roll-up covers, and owners on user forums say the EZ-Lift is a noticeable step up from the original MX4 in ease of use. Premium-grade, multi-layer aluminum construction over a high-density core
The main buying argument is the EZ-Lift mechanism. A torsion spring on the cab side reduces lifting effort, and the oversized paddle latch releases the cover one-handed, even with gloves on. Folds to the cab for full bed access—no removal needed for large cargo, and the manufacturer says the cover does not block the third brake light or the OEM camera. Owners on user forums report that the paddle latch is the most noticeable upgrade over the original cable-release design. Searchers looking for a 2015–2022 Colorado 5 ft bed hard tonneau, torsion-assist tonneau, or EZ-Lift full-bed-access cover will find this part's specifics below.
The manufacturer states the MX4 EZ-Lift does not block the third brake light or OEM camera in any position.
Owners on user forums report that the EZ-Lift rails are notched for the new retaining clamps, so an original MX4 setup will need new rails for this cover.
Owners on user forums report that the instructions call for shims on GM beds unless the clamps are placed roughly one-third of the way in from the front and rear of the bed.
The manufacturer describes a bolt-on, click-in installation with the included clamps and no drilling, typically completed in 30 minutes or less at a Level 1 difficulty. Over- or under-tightening the clamps can cause product failure or damage to the truck, so tighten until snug and then add a further half turn. Owners on user forums recommend a second person for handling the cover during the install, and they advise confirming the clamp and shim layout against the sheet before fully tightening.