The Mishimoto MMTS-MB62-08L is a 180-degree racing thermostat for the M156 6.2L V8 in the 2008-2012 Mercedes-Benz C63 AMG. The manufacturer says it opens at 180°F, while the factory unit opens at 212°F, so coolant can start circulating through the engine sooner. It is sold as a direct-fit replacement and includes the thermostat and a rubber O-ring. Mishimoto backs it with a lifetime warranty.
The case for this part over stock is earlier coolant flow, which the manufacturer presents as a way to keep operating temperatures lower during hard driving and hot-weather track days. Owners on user forums are split on how much it helps. Some say the main gain is a faster warm-up and little change once the engine is fully up to temperature, and others report a cooler coolant reading on the track. Buy it for the lifetime warranty and the lower opening point, not as a guaranteed fix for heat soak. Shoppers searching for a C63 AMG M156 180 degree thermostat, W204 track cooling upgrade, or M156 thermostat for track days should check that their model year and housing match before ordering.
The manufacturer states that installation requires the Mercedes-Benz 1562030475 housing. Check your existing housing part number before ordering.
The manufacturer lists one thermostat and one rubber O-ring in the box, so confirm that your housing seal is in good condition before reassembly.
Owners on user forums report mixed results. Many describe the main benefit as faster warm-up, and some report only small differences in running temperature once the engine is fully warm.
The manufacturer rates installation as easy. The stock thermostat must be removed and the Mishimoto unit installed in its place, so this is a swap rather than a modification. Owners on user forums advise catching as much coolant as you can when removing the old thermostat, and inspecting the sealing gasket before reassembly, since one owner reported a gasket failure that partly jammed the valve closed on track. Confirm the housing matches the manufacturer's 1562030475 requirement before you start. Specific tool requirements and torque values were not confirmed in this research, so check the manufacturer's install documentation for those details.