The Mishimoto R1553 is a direct-fit replacement radiator for the 5.9L Cummins in 1994–2002 Dodge Ram 2500 and 3500 trucks. It pairs an aluminum core with plastic end tanks, the same basic construction as the factory unit, and the manufacturer says it installs without cutting, bending, or adjustments. It is built for owners replacing an aged, clogged, or leaking stock radiator, so it suits a 94-02 Dodge Ram 2500 5.9L Cummins replacement radiator job rather than a high-capacity cooling upgrade.
Choosing this over a bargain radiator comes down to warranty and fit. The Mishimoto Lifetime Warranty backs the unit, and the manufacturer positions it to restore stock-level cooling on a 2nd Gen Cummins that is overheating from a plugged core or a cracked tank. Owners on user forums often identify the plastic end tanks as the first failure point on aging trucks, so a new unit with a warranty addresses that risk directly. The radiator ships without a cap, and the manufacturer recommends a high-pressure cap such as the MMRC-13L, which is worth adding on a truck that tows. For a build that needs more heat rejection, the brand's all-aluminum performance radiator is the better route.
Mishimoto rates this as an easy install. Owners on user forums describe the job as straightforward: drain the coolant, remove the fan shroud bolts, disconnect both hoses and the overflow line, unbolt the radiator, and lift it out. Watch for a tight washer fluid reservoir that may need prying from its bracket, and note that on some trucks the radiator must come out before the intercooler can be removed. Plan for a full coolant flush and refill when you finish.
No. The manufacturer states the radiator does not include a cap and recommends a high-pressure cap such as the MMRC-13L.
The manufacturer says it installs with no cutting, bending, or adjustments needed.
Owners on user forums report that on their trucks the radiator has to come out before the intercooler can be removed, so plan the job around that if you are pulling the intercooler.
The manufacturer lists this as an easy installation with one part. Drain the cooling system first, then remove the fan shroud bolts, disconnect the upper and lower radiator hoses and the small overflow hose, and remove the bolts that hold the radiator to the core support. Lift the radiator straight up and out. Expect the washer fluid bottle to be the most stubborn component, since owners on user forums say it can take a flat-blade screwdriver to pry it free from its bracket. Refill with the correct coolant and check for leaks after the first heat cycle.