The Mishimoto 92-99 BMW E36 Manual Aluminum Radiator (MMRAD-E36-92) is a full-aluminum replacement for the factory radiator. The manufacturer builds its end tanks from aircraft-quality aluminum, TIG-welded to a brazed aluminum core. That matters because the factory plastic-tank units are a known failure point, and the manufacturer says the all-aluminum design avoids the plastic-tank failures seen under sustained heat (All-aluminum construction with TIG-welded tanks replaces plastic-tank failures common in factory units under sustained thermal stress.). The two-row core is 1.57-in thick. The manufacturer pitches it for a daily-driven E36 M3 or an M20 running a large turbocharger, on and off the track (this E30 and E36 radiator provides ideal temperatures on and off the track). It also ships with the Mishimoto Lifetime Warranty.
Verify fitment before you buy. The manufacturer describes a fit that is confirmed direct fit for the 1988–1999 BMW E30/E36 with 6-cylinder engine, with no cutting, fabricating, or adapter work required, but its transmission-cooler note refers only to 1988–1991 models. Details also vary on whether automatic cars are covered, so confirm with the manufacturer. For installation, the manufacturer says the overflow and temperature sensor ports are present for use with stock sensors and hoses, so you can keep your factory parts. Searchers looking for an E36 325i or 328i radiator upgrade, an E36 manual transmission cooling swap, or an E36 track-day radiator will find this unit fits that use.
The manufacturer's product page references mounting points for the factory transmission cooler, but fit details for automatic cars vary across sources. Confirm your transmission type and model year with the manufacturer before ordering.
Yes. The manufacturer states that a magnetic drain plug is included and that no additional hardware is needed for a complete install.
Per the manufacturer, all factory overflow and temperature sensor ports are present, so OEM sensors and hoses are intended to bolt on to the new radiator.
Owners on user forums commonly open the radiator's top bleed screw, fill slowly through the expansion tank until coolant runs with no bubbles, then close the screw and top off the level after the engine warms up.
The manufacturer's fitment note describes a direct bolt-in swap that requires no modification to the vehicle, so this is a radiator replacement rather than a custom fabrication job. Drain the old coolant first and use the magnetic drain plug on the new unit. Owners on user forums report that if the system will not bleed fully, a collapsed hose, a stuck heater valve, or a reversed heater hose is often the cause, so check those before replacing parts. Before refilling, confirm that the transmission cooler lines and mounts match your car, since automatic-versus-manual details vary. For the manufacturer's install guide, check the Mishimoto product documentation.