The Mishimoto MMHOSE-MOP62-15RD is a replacement upper and lower radiator hose set for the 6.2L supercharged Hellcat V8 in 2015 and later Dodge Challenger and Charger SRT models. Mishimoto builds these hoses from a combination of high-grade silicone and heat-resistant embedded fibers as a replacement for OEM rubber hoses. The hoses keep OEM fitment while adding pressure tolerance. Rubber hoses that have been cycling heat and pressure for years are a common weak point, and this red kit is a direct swap for them.
Compared with a cheap generic rubber hose, this kit's five-layer silicone build is the reason to pay more. The silicone layers are built to withstand heat a lot better than the stock parts they replace. The red finish also brightens up a supercharged engine bay. Fitment is listed for 2015-2023 Dodge Hellcat 6.2L SC applications, so buyers searching for a Hellcat upper radiator hose, a Challenger Hellcat coolant hose upgrade, or a 6.2L supercharged silicone radiator hose kit can confirm their car is covered before ordering. The kit includes two silicone hoses and five worm gear clamps.
Installation is rated easy by the manufacturer, but owners on user forums describe it as the slowest part of a radiator-area job. One owner reported removing the front fascia, taking care not to break its side clips, and dropping the lower radiator support so the radiator could come out. The hoses were the hardest part to free from the radiator and water pump connections, and some owners twisted them or used a hose removal tool to break the seal. Plan for extra time at the connections.
Yes. The manufacturer lists five worm gear clamps along with the two silicone hoses.
The manufacturer lists a direct fit for 2015 through 2023 Dodge Challenger and Charger SRT Hellcat models with the 6.2L supercharged V8.
Owners on user forums report that the front bumper fascia and lower radiator support are removed so the radiator can be lifted out, which makes the hoses easier to reach. Confirm your own procedure with the manufacturer's guidance before starting.
The manufacturer rates this kit as an easy install, and it ships with the worm gear clamps needed to secure both hoses. Owners on user forums suggest pulling the front fascia straight off rather than one side first, since its upper side clips break easily. Expect the hardest work at the hose ends, where the old rubber can stick to the radiator and the coolant line running along the bottom of the lower radiator support can be awkward to reach. Gentle twisting or a hose removal tool usually helps. Basic hand tools and a clamp tool are the practical requirements for this job.