This is Mishimoto's black silicone coolant hose set for the 2007-2013 Chevrolet Silverado 1500 V8. The hoses use four-ply silicone with heat-resistant embedded fibers, which the manufacturer describes as improving tolerance to heat and pressure over stock hoses. Owners on user forums say silicone holds up across a wider temperature range than the rubber used on factory hoses, so this kit suits a truck that tows, idles in traffic, or runs hot. Each set includes the Mishimoto Lifetime Warranty.
Because the kit is a direct-fit replacement, you get two silicone hoses and four high-quality worm gear clamps in one box. The manufacturer rates installation as easy and recommends 22 in-lbs of clamp torque, with a maximum of 27 in-lbs, so use a torque driver rather than guessing. Owners on user forums recommend sleeved or constant-tension clamps on silicone, since plain worm clamps can notch the hose wall. Search terms this kit targets include 2007-2013 Silverado 1500 V8 silicone radiator hose, black coolant hose kit, and Silverado V8 cooling system upgrade.
The manufacturer recommends 22 in-lbs (2.5 Nm) for all worm gear clamps, with an operating range of 18-27 in-lbs. Do not exceed 27 in-lbs (3 Nm).
Yes. The manufacturer lists four high-quality worm gear clamps in the kit alongside the two silicone hoses.
Owners on user forums generally advise against plain worm clamps on silicone because the screw notches can cut into the hose, and they recommend sleeved or constant-tension clamps instead.
The manufacturer rates this kit as an easy install, and it includes everything needed for the two hoses. Work only on a fully cooled engine, and drain the cooling system first, capturing the coolant for proper disposal, as the manufacturer's radiator guide advises. Inspect the factory connection points as you go, since a new silicone hose has to seat squarely over the fittings. Tighten each worm clamp to the recommended 22 in-lbs and recheck for leaks after the first heat cycle; owners on user forums report that worm clamps often need a retorque after the engine warms up. Confirm your trim and engine configuration with the manufacturer before ordering, since application details may vary.