The Mishimoto MMFS-GC8-93 is an aluminum fan shroud kit built for the 1993-1998 Subaru Impreza GC8 chassis. It ships with a polished aluminum shroud, two 12-inch slim electric fans, and all mounting hardware, and the manufacturer says it fits both stock and Mishimoto GC8 radiators. Fitment is narrower than the product title implies: the manufacturer limits this kit to non-turbo, 2.2L models, so confirm your engine before ordering if you are looking for a turbo GC8 WRX fan shroud.
Compared with the factory shroud, this aluminum housing removes considerable weight while delivering more air across the radiator core, which is the practical reason to choose it over a basic fan swap. The manufacturer rates each fan at 1150 CFM. Owners on user forums describe more stable coolant temperatures after installation. Enthusiasts searching for a 1993-1998 Impreza GC8 electric fan and shroud upgrade, a 2.2L overheating fix, or a slim 12-inch fan shroud for an aluminum radiator will find this kit matches those needs, and the Mishimoto lifetime warranty backs the purchase.
The manufacturer lists this kit for non-turbo models with 2.2L engines only, even though the product title uses the WRX name. Confirm your engine type with the manufacturer before buying.
The manufacturer says the shroud fits both stock and Mishimoto GC8 radiators. Owners on user forums report good fitment with aftermarket radiators, but they also warn that a thicker radiator core can crowd the slim fans, so measure your clearance first.
The manufacturer's instructions do not call for it. Owners on user forums say they applied blue threadlocker to the fan and shroud mounting fasteners to keep them from loosening under engine vibration.
The manufacturer rates installation as easy. Plan on draining the coolant, removing the reservoir from the factory shroud, unplugging the fan harness, and unbolting the stock shroud after removing the lower splash shield. The manufacturer's general shroud guide for a related 2001-2007 kit calls for ratchets, 10mm and 12mm sockets, and a coolant funnel. Mount the new shroud, reattach the reservoir, refill with a 50/50 mix of coolant and distilled water, then start the car with the heat set high and check for leaks and fan operation. Owners on user forums recommend test-fitting the shroud before wiring the fans and using rubber weatherstrip to close any gap around the radiator. Because the manufacturer notes the fans may need additional wiring, budget time for the electrical work.