Mishimoto's Silicone Induction Hose in blue is a direct-fit replacement for the factory turbo inlet hose on the 2008–2014 Subaru WRX, and the manufacturer also lists the 2005–2009 Legacy GT and Outback XT. It is built from high-grade silicone with heat-resistant embedded fibers and wire-reinforced with molded steel rings, so it resists the vacuum collapse that can affect unreinforced silicone hoses at high boost. Owners on user forums frequently point to that collapse risk with plain silicone inlets, which makes the reinforced construction the main reason to pay more than for a basic silicone hose. The manufacturer also cites a larger internal diameter for better airflow, a quicker turbo spool, and CNC-machined aluminum fittings with a three-barb design that stay seated under load. Because it needs no tune, it is a practical bolt-in upgrade for a stock or Mishimoto-equipped intake setup. Search terms like 2008 WRX turbo inlet hose, EJ25 silicone inlet, and MMHOSE-SUB-08IHBL will match this part.
Fitment works with the stock airbox setup or with Mishimoto's WRX/STI cold air and race intakes, so you can keep your current intake or pair the hose with an upgrade. The manufacturer rates the installation as hard, and owners on user forums describe it as a tedious job that can take anywhere from roughly 30 minutes to several hours. Many installers report that the intake manifold does not have to come off, but some choose to loosen or remove it for extra room. Warming the silicone in the sun makes it easier to flex through the engine bay, and a light coat of marine grease helps it slide over the turbo and fittings. Check clearance around the power steering pressure line before you start, since that line is a common obstruction during removal of the stock hose.
The manufacturer states it fits with the stock intake and with Mishimoto's WRX/STI Performance Cold Air Intake or Race Intake.
The manufacturer lists the hose as requiring no tune.
The manufacturer lists the Legacy GT and Outback XT for 2005–2009 as direct-fit applications.
Owners on user forums report that many installs were completed with the manifold in place, usually by cutting the stock hose out in pieces. Others removed the manifold to get more room and to reach the injectors or other components at the same time.
The manufacturer rates this install as hard, and owners on user forums describe it as one of the more frustrating intake-side jobs on these cars. Plan for a long session, and expect to spend time freeing the stock hose, which some owners cut apart in sections rather than trying to pull it out whole. The kit includes the T-bolt clamp for the turbo and the worm-gear clamps, so you will not need to source them separately. Before you begin, read the manufacturer's install guide, which is available as a PDF from Mishimoto, and keep marine grease and a few spare clamps on hand. Work the new hose gently over the turbo, warm the silicone for flexibility, and confirm the hose sits cleanly before final tightening.